...
| Code Block | ||||||||
|---|---|---|---|---|---|---|---|---|
| ||||||||
#PARSER PQL |
#QName
Set the name of the following queries.
| Code Block | ||||||||
|---|---|---|---|---|---|---|---|---|
| ||||||||
#QNAME Query1 |
#QUERY
This command executes a query in a certain language. This might be, for example Procedural Query Language (PQL) or Continuous Query Language (CQL). There are three different commands to execute such a query: #QUERY, #ADDQUERY and #RUNQUERY. While #QUERY and #ADDQUERY (they are one and the same) only passes the definied query to Odysseus, the #RUNQUERY additionally starts the query. This means, a query that was added with #QUERY or #ADDQUERY is inactive and not started until it is explicetely started. The #RUNQUERY in contrast immediatly starts a query after it is added, e.g. by using #STARTQUERIES .
...
The query command is dependent on the current parser (which is set by #PARSER) and the current transformation configuration (which is set by #TRANSCFG). Therefore, it is necessary to run these two commands before. Furthermore, you can switch to other parsers / transformation within one script by using #PARSER or #TRANSCFG again. Thus, if you want to run a query in CQL that last #PARSER command before should set the parser to "CQL".
If #QName is defined before, the query will get this name.
Example
The example shows four queries after the parser is set to CQL and the transformation configuration is set to Standard. The first one uses #QUERY and it is executed as a CQL-Query, but not started. The second query is equal to the first one (it still uses CQL and is not started). The third query also uses CQL and the Standard transformation configuration, but is (in contrast to the first and second) started (it is directly running). Then, the parser is switched to PQL, so that the fourth query is parsed by the PQL-Parser and not by the CQL-Parser anymore.
...